Please wait while the page loads...

Acura Check Engine Light Flashing

Although there are countless possible causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are a few common causes including something as common as a loose gas cap. Further common reasons for a Check Engine Light are faulty emissions control part, damaged oxygen sensor, a malfunction with the fuel injection system, faulty head gasket, dirty mass airflow sensor, or defective spark plugs to name innumerable. No matter what is the root cause of the Check Engine Light, we have the Acura Certified Technicians and the certified service protocol to isolate the root problem and repair it as essential to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Acura issue was fixed.

Every Acura was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its critical systems. The sensors are frequently detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what absolutely is wrong nor what to do about it. That’s where we come in; Crown Acura Richmond provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Very Qualified Service professional.

Acura Check Engine Light

If the check engine light in your Acura starts twinkling, that means that the problem needs abrupt attention and your Acura should be delivered in immediately. A twinkling light hints that the problem is unhealthy and if not taken care of immediately may result in big damage to the vehicle. This blinking light ordinarily expresses a relentless engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can immediately increase the temperature of the catalytic converter to a point where damage is conceivable, requiring an costly repair. Some owners ask if spark plugs cause the check engine light to flash? This can fully be the cause. A bad, common or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair. If your check engine light is flashing, please contact our team of automotive experts at Crown Acura Richmond expeditiously by calling 8043618447.

How much does it cost to get the engine light checked?

The average cost for a check engine light diagnosis & testing is frequently between $88 and $111. The superb news, Crown Acura Richmond offers complimentary multi-point inspections and free diagnostics, in most cases, to help represent the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not properly tightened to a more strict failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it superb to get the essential code reading and diagnosis.

Is it safe to drive your Acura with the check engine light on?

If the check engine light is flashing, this means that there is a serious issue and it is recommended to service your Acura hastily. This question is not very easy because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be dependable to drive. This is normally indicated by a dependable glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more unhealthy problem. Call the experts at Crown Acura Richmond by dialing 8043618447 so you can describe the issues. Or decrease your speed and bring your Acura to our certified mechanics as soon as achievable.

What Does the Check Engine Light Mean?

One of the most generally misunderstood lights or indicators in your Acura is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in assorted individual ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your Acura. Some of these include shifting automatic transmissions ignition timing, controlling engine speed, and implementing stability control, just to name a few. With that being said, the check engine light can mean a collection of definite things. It can be as apparent as your gas cap being loose or as scrupulous as engine knocking. If your check engine light is on in your Acura, contact Crown Acura Richmond. Our Acura service department can help you determine what code is turning your check engine light on or inspect why your check engine light is flashing. Contact Crown Acura Richmond today!

How many miles can you drive with the check engine light?

Since each check engine code has its own level of severity, it is rigid to predict how bountiful miles you can travel to work with the warning light on. The safest bet is to decipher the code and then plan your strategy accordingly. If you check engine light is flashing, we recommend that you pull over and contact Crown Acura Richmond to help select if your vehicle is safe to travel to work in or if we recommend a tow truck. It could be anything from a harmful sensor to plug wires needing to be replaced.

Acura Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard suddenly illuminates, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also established as the OBD (on-board computer diagnostic system) in your. There are hundreds of various codes that your check engine light can represent. While that sounds daunting, with a little patience, tackling dominant diagnostics will give you available knowledge about your vehicle and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Sadly, definite and helpful vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of achievable OBD codes, there are also hundreds of achievable reasons for the light, including:

  • Transmission issues
  • Fuel and air metering systems problems
  • Computer output circuit issues
  • Loose Gas Cap or Missing Gas Cap
  • Emissions controls issues
  • Ignition system faults
  • Old Battery
  • Bad Spark Plugs
  • O2 Sensor

This is why it is good for someone who does not have various of automotive knowledge to not assume what a code means. Call Crown Acura Richmond at 8043618447 today or schedule your check engine light service online today! When your check engine light comes on, you should get it checked out instantly by a certified Acura mechanic. If the engine light comes on due to a hazardous concern, you risk damaging your car further by not repairing the issue right away.

Check Engine Light Service Acura

What do you do when you’re driving along in your Acura and quickly, a yellow light lights up on your dash and says "Check Engine". If you’re like most Acura owners, your heart sinks a tiny because you have tiny idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t hint you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your Acura checked as soon as achievable. Ignoring that warning could end up causing major damage to expensive engine components.

When your Acura 's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t sane, a computer turns on your check engine light. This amber or yellow light is mostly labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electronic scan tool that is used by our Acura auto repair mechanics at Crown Acura Richmond. There are also a number of relatively inexpensive code readers that are designed for do-it-yourselfers, should you elect for that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced experienced to pick the issue and repair it.

Will the check engine light reset itself?

The check engine light on your Acura will commonly shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going exact, and you did a few of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your Acura light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to transport it in to Crown Acura Richmond so the light and code can be double-checked and reset.

What could cause the check engine light to come on in a Acura?

When your check engine light comes on, this could be as easy as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a relentless problem that could cause relentless damage to your engine and come with a great repair bill. Depending on your make and model, the check engine light will illuminate or blink. A convincing glow regularly means something less relentless but a flashing check engine light indicates that your vehicle’s engine is in relentless trouble and service is mandatory quickly. If your check engine light is flashing in your Acura, we immensely advocate not to drive the vehicle and schedule Acura service now. Below is a list of the most ongoing reasons your check engine light can come on:

  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Acura is what determines how much fuel is basic to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to genuine changes, like altitude. If your Acura is having trouble starting, idling rough or has a sudden change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or alternative item can wreak havoc on your Acura if it’s not installed appropriately. These aftermarket parts and accessories can drain the battery, trigger the check engine light, or even impede the vehicle from starting. If these issues sound accepted, bring your to Acura and have our team of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, highly aftermarket parts and accessories, or using OEM parts earliest place might price a small bit more but could save you money from having to get poor work and damage caused by poor installation work corrected.
  • New Spark Plugs or Plug Wires are basic for your Acura. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires bring the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or classical, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, big to more expensive repairs.
  • The battery is low or dead. The battery in your Acura is every giant. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did assorted decades ago, and they don't genuinely require maintenance. The rate of a new one depends on the type of Acura you drive, but check our current service coupons and specials.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your Acura ’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is usually caused by neglected maintenance, which is why Crown Acura Richmond offers a complimentary multi-point inspection with every Acura service. If you have an issue with your catalytic converter and don't get it repaired, your Acura will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause alternative problems from overheating.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, acknowledged as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less effective when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your Acura 's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to opt for the right mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • Your Acura has a vacuum leak. Every Acura has a vacuum system that performs a wide mixture of functions. The vacuum system also helps reduce harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, highly if they’re exposed to awesome heat or extreme chilled.
  • One of the most typical and plentiful cause is that your Acura gas cap is loose, damaged or missing. The gas cap for your Acura serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is classical or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on today after you put gas in your Acura, earliest thing you should check is to make hopeful the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.